Neko Tail in 10 simple steps

LINK :

http://www.youtube.com/watch?v=wUfgA_Nam40

http://www.youtube.com/watch?v=saTRFSxXvzI

10 simple steps to make yourself a moving neko tail.

1. Measure the length from hip to foot.
2. Adjust the width according to the diameter.
3. Sew both side together
4. Cut off the remaining fabric.
5. Start stuffing in the cotton
6. Pus the cotton to the end using chopstick or something long and thin.
7. Tie the end with a strong thread.
8. Make a curve at the front tail and sew it with fishing thread.
9. Sew a long fishing thread at the tip of the tail.
10. Attach the tail to a rubber strap.

That's all ..!! You can now wear the tail and control it using the long fish string that is attached to the tail .
just as easy as that !!

How to Defrizz Synthetic Wig

Hey guys.. I have something awesome to share with you guys !!~
Having problem with your frizzy wig??

I found Jeez Louise method and it works pretty well..

She uses Iron Curler but I'm using Iron .. kindly visit her blog if you choose to use curler.

TRY THIS ON YOUR RISK !!(using Iron)
1. Set your IRON to the lowest heat. (my iron has setting for nylon)
2. Grab the part of frizzy wig.
3. Try detangle them the best you could.
4. Spray some water on it.
5. Prepare yourself as you might ruin the wig.
6. Run the Iron across a paper to test the heat.
7. Place the Iron on the wig then pull the wig across it.
8. Quickly repeat step 3 to 7 again until it's totally defrizz completely.
9. Now move on to the next frizzy part.
10. Continue and you're DONE =D

**NOTE :
i. Never set your Iron temp too high.
ii. Start by small portion.
iii. If you want a curly wig, use a round wig comb and comb it right after being ironed.
iv. Steam Iron are not recommended.
V. Needs lots of time and patient.

And surprising it WORKS !!!

Though there's still a tiny frizzy part but it's whole lot better than before..